In stock will ship within 2 buisness days
Whether you're doing an HID or LED install in your headlights or looking for an inexpensive upgrade, installing some clear reflectors in place of the amber will give your headlights a clean new look that will set you apart.
If clear isn't your thing, we can do the reflectors in smoked or any other custom colors.
Our lenses are an exact duplicate of the OEM so they fit great and provide a clean OEM look.
TO INSTALL THESE SIDE MARKERS YOU WILL NEED TO CUT OPEN YOUR HEADLIGHTS
The process to open up most headlights is the same, here are some tips that should help for most headlights.
PREHEAT (very important to preheat) your oven to around 150 degrees F. While it is preheating, remove any screws on the backside of the headlight which hold the lens to the housing (if present). Once oven is preheated, place one headlight in the oven for ten to fifteen minutes. Remove headlight, then you can use a couple flathead screwdrivers to carefully pry the clear lens off.
If the sealant is not softening in the oven you might need to cut it apart using a dremel or oscillating tool. Many of the newer headlights use permaseal which has to be cut or is just harder to separate.
BE SURE not to touch the inside of the lens or the chrome housings as they will be perfectly clean. This will prevent you from have to clean or polish them later. Remove the inside bezel and swap out the amber lenses for the clear, in most cases they will need epoxied in.
To reassemble the headlight with soft sealant, place in oven for another 10-15 minutes, then clamp together and reinstall the screws. This should seal up your headlight for you, but I like to supplement with a nice bead of clear silicone all around the outside as well as a backup. Or you can use some new butyl to seal up the headlights.
These are just generic instructions but it should be helpful for most headlights, there are alot of videos on youtube as well.